Download Table of Contents Print this page

Makita DA4000LR Instruction Manual

Angle drill
Hide thumbs Also See for DA4000LR:

Advertisement

INSTRUCTION MANUAL
Angle Drill
DA4000LR
003009
DOUBLE INSULATION
WARNING:
For your personal safety, READ and UNDERSTAND before using.
SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
1

Advertisement

Table of Contents
loading

Summary of Contents for Makita DA4000LR

  • Page 1 INSTRUCTION MANUAL Angle Drill DA4000LR 003009 DOUBLE INSULATION WARNING: For your personal safety, READ and UNDERSTAND before using. SAVE THESE INSTRUCTIONS FOR FUTURE REFERENCE.
  • Page 2: Specifications

    EC Declaration of Conformity and can, therefore, also be used from sockets without earth wire. Makita Corporation responsible ENG104-2 manufacturer declare that the following Makita Noise machine(s): The typical A-weighted noise level determined according Designation of Machine: to EN60745: Angle Drill...
  • Page 3: General Power Tool Safety Warnings

    Europe who is: Keep cord away from heat, oil, sharp edges or Makita International Europe Ltd, moving parts. Damaged or entangled cords Michigan, Drive, Tongwell, increase the risk of electric shock.
  • Page 4: Drill Safety Warnings

    Power tool use and care the operator an electric shock. 18. Do not force the power tool. Use the correct Always be sure you have a firm footing. power tool for your application. The correct Be sure no one is below when using the tool in power tool will do the job better and safer at the high locations.
  • Page 5 Use of it without angle attachment Reversing switch action 1. Reversing switch lever 004652 003029 Screw the side grip on the tool barrel securely. The side This tool has a reversing switch to change the rotational grip can be installed on either side of the tool, whichever direction.
  • Page 6 CAUTION: 1. Hex wrench Be sure to tighten the two bolts firmly, or it may • 2. Loosen present a risk of injury to persons. Slide the drill chuck to the spindle so that the two faces are fitted perfectly. Holding the drill chuck with the chuck key, tighten the bolt (for installing the drill chuck) clockwise with the hex wrench firmly.
  • Page 7: Operation

    If you need any assistance for more details regarding these accessories, ask your local Makita Service Center. MAINTENANCE Drill bits •...
  • Page 8 Makita Corporation Anjo, Aichi, Japan 884392E229...

Table of Contents