Impex MFB 400 Owner's Manual page 8

STEP 2 (SEE DIAGRAM 2)
A.) Attach the Leg Developer Holder (#5) onto the Front Stabilizer (#7). Secure it with three
M8 x 5/8" Allen Bolts (#38) and Ø 5/8" Washers (#46).
B.) Connect the Main Seat Support (#6) to the Leg Developer Holder. Secure the front hole
with a M10 x 2 1/8" Allen Bolt (#37), two Ø ¾" Washers (#44), and one M10 Aircraft Nut
(#47). Note: Do not over tighten the Nut and Bolt. The Leg Developer Holder needs to
pivot on this Bolt in able to fold up. Secure the other hole with a 3 3/8" Lock Pin (#22).
C.) Attach the Main Seat Support to the bracket on the Cross Brace (#3). Align the second
hole on the Main Seat Support to the rear hole on the bracket. Secure them with one M10
x 2 1/8" Allen Bolt (#37), two Ø ¾" Washers (#44), and one M10 Aircraft Nut (#47). Note:
Do not over tighten the Nut and Bolt. The Main Seat Support needs to pivot on this Bolt in
able to fold up. Insert a 6" Lock Pin (#23) into the first hole on Main Seat Support.
D.) Thread a M10 Lock Knob (#24) from the bottom of the Cross Brace to secure the Main
Seat Support.
7
DIAGRAM 2