Setting Up A Usb Driver - Motorola SBV5121 User Manual

Introduction
8
To connect the telephone line, plug a phone wire into the Tel 1 connector. You can also connect a second
telephone line to the Tel 2 connector.
Caution!
To reduce the risk of fire, use only No. 26 or larger UL Listed or CSA Certified Telecommunication
Line Cord to connect a telephone line to your SBV5121 VoIP cable modem.
Do not connect both the Ethernet and USB cables to the same computer. Connect to either Ethernet
or USB.
Contact your cable provider before connecting your VoIP cable modem to your existing telephone wiring.
Do not connect the telephone wire to a traditional telephone (PSTN) service.
Be sure the phone connectors are neither connected together nor connected to wall jacks on the
same network.

Setting Up a USB Driver

The following subsections describe setting up a USB driver. Before connecting a PC to the USB port, perform the
appropriate procedure for your Windows version:
•
"Setting Up a USB Driver in Windows 98 Second Edition"
•
"Setting Up a USB Driver in Windows 2000"
•
"Setting Up a USB Driver in Windows Me"
•
"Setting Up a USB Driver in Windows XP"
When you finish setting up the USB driver, you can continue with
The SBV5121 VoIP cable modem USB driver does not support Macintosh or UNIX computers. For those systems,
you can connect through Ethernet only.
Caution!
Be sure the SBV5121 VoIP Cable Modem CD-ROM is inserted in the CD-ROM drive before you plug
in the USB cable.
SBV5121 VoIP Cable Modem User Guide
Installation Troubleshooting
Either/or
+12VDC
on page 11
on page 15
on page 18
on page 19
"Configuring TCP/IP"
Glossary License
on page 20.
10