Setting Up A Usb Driver - Motorola SURFboard SBV5222 User Manual

Introduction
7
Perform the procedures for
8
To connect the telephone line, plug a phone wire into the Tel 1 connector. You can also connect a second
telephone line to the Tel 2 connector if your provider has enabled a second line.
Caution!
To reduce the risk of fire, use only No. 26 or larger UL Listed or CSA Certified Telecommunication
Line Cord or national equivalent to connect a telephone line to your SURFboard Digital Voice Modem.
Do not connect both the Ethernet and USB cables to the same computer. Connect to either Ethernet
or USB.
Contact your cable provider before connecting your digital voice modem to your existing telephone wiring.
Do not connect the telephone wire to a traditional telephone (PSTN) service.
Be sure the phone connectors are neither connected together nor connected to wall jacks on the
same network.

Setting Up a USB Driver

The following subsections describe setting up a USB driver. Before connecting a PC to the USB port, perform the
appropriate procedure for your Windows version:
•
"Setting Up a USB Driver in Windows 2000"
•
"Setting Up a USB Driver in Windows XP"
When you finish setting up the USB driver, you can continue with
The SURFboard Digital Voice Modem USB driver does not support Macintosh or UNIX computers. For those
systems, you can connect through Ethernet only.
Caution!
Be sure the SURFboard Voice Modem CD-ROM is inserted in the CD-ROM drive before you plug in
the USB cable.
SBV5222 SURFboard® Digital Voice Modem
Installation
"Configuring TCP/IP" on page 17.
on page 13
on page 16
Troubleshooting
Either/or
"Configuring TCP/IP"
Glossary License
on page 17.
12