Displaying And Setting The Water Hardness Level - Miele HG06 Operating Instructions Manual

Displaying and setting the water
hardness level
 Turn the dishwasher off with the 
button, if it is turned on.
 Press the Start button and, simulta‐
neously, switch the dishwasher on
using the  button.
Keep the Start button pressed for at
least four seconds until the Start indi‐
cator light comes on.
If this does not happen, start the proce‐
dure from the beginning again.
 Press the  button twice.
The  indicator light will flash twice at
short intervals.
Before using for the first time
The value which has been set for the
water hardness appears as a figure in
the time display (see table) according to
.
  will start flashing in the time display.
This is the factory default setting of 1°.
 Use the Start button to select the val‐
ue which equates to your water hard‐
ness level.
Each press of the button moves you
up a level. When the highest water
hardness level is reached, the setting
starts from the beginning again.
The setting is now stored in memory.
 Turn the dishwasher off with the 
button.
19