Table of Contents
Advertisement
Displaying and setting the water
hardness level
Switch the dishwasher off with the
button if it is switched on.
Press the Start button in and, whilst
holding it in, switch the dishwasher
on using the button.
Keep the Start button pressed in for
at least four seconds until the Start
indicator light comes on.
If this does not happen, start the
procedure from the beginning again.
Press the Delay start button twice.
The indicator light will flash rapidly
twice at intervals.
Before using for the first time
The value which has been set for the
water hardness is shown as a figure
after in the display (see chart).
will start flashing in the display.
This is the factory default setting of
0.2 mmol/l (1 °d - German scale).
Use the Start button to select the
value which equates to your water
hardness level.
Each press of the button moves you
up a level. When the highest water
hardness level is reached, the setting
starts from the beginning again.
The setting is now stored in memory.
Switch the dishwasher off with the
button.
21
Advertisement
Table of Contents
