Loading The Ribbon - Paxar 9662 User Manual

Peeler
Sensor
Cutter
7
Rewinder
Peel Off Mode
Cutter Mode

Loading the Ribbon

Notes:
1. This section is applicable to the transfer thermal printing.
2. Attached ribbon is coating inside.
1. Lift the top access door and the front access door to expose the
compartment. ( Figure 1 )
2. Push the head latch by anti-clockwise, and then fold the bracket.
( Figure 2 )
3. Unwrap the ribbon roll pack and separate the ribbon roll and the bare
core.
4. Insert the ribbon roll into the ribbon supply spindle. ( Figure 3 )
5. Lead the bare core through the print head module. ( Figure 4 )
6. Attach the edge of the ribbon on the bare core and wind it a little bit
onto the core.
Note:
The dull side of the ribbon should be faced down.
7. Insert the bare core into the ribbon pick-up spindle. ( Figure 5 )
8. Turn the pick-up spindle to ensure the ribbon is tightly wound.
1
Front Access
Door
Top Cover
8