Thetford N614E.3F Installation Manual page 11

- Remove the three plastic hole caps that are near the strike plate.
- Remove the L-shaped plastic covers that are opposite the hinges.
- Remove and save the screws from the upper cabinet hinge [66a] of each door.
- Put each of these hinges on the other side of the refrigerator as the lower
hinge [66b].
- Attach each of these hinges with screws.
- Remove and save the screws from the lower cabinet hinge [67a] of each door.
- Put each of these hinges on the other side of the refrigerator as the upper
hinge [67b].
- Attach each of these hinges with screws.
- Remove and save the screw [41] from the control end cap.
- Pull the control end cap away from the refrigerator and out from under the control housing.
- Carefully pull the button label from the front of the control housing and
set it aside. (See Art02459)
- Remove and save the two (2) screws from the control housing.
- Pull the control housing away from the display board assembly and set
the control housing aside.
- While holding the display board assembly, remove and save the two (2)
screws from the display board assembly.
- Move the display board assembly to the same hole position on the
opposite side of the refrigerator.
- Attach the display board assembly to the refrigerator using two (2)
screws.
Make sure that you do not pinch any wires and or loosen
NOTICE
any connectors from the display board.
- Align the holes of the control cover with the mounting holes on the display board assembly.
- Attach with two (2) screws.
NOTICE
Make sure that you do not pinch any wires.
- Align the button label with the recess in the control housing and press it into position.
- Put the strike plate on the opposite side of the refrigerator [65b].
- Put the three round plastic caps into the holes that are near the strike plate.
- Put the L-shaped plastic covers over the holes that were used by the hinges.
Installation / Owner's Manual 11
68
Art02446
Art02459
41
69
41