Checking Suspension Fluid Ahc; Checking Brake Fluid; Engine Oil - Toyota 2006 Land Cruiser Owner's Manual

Checking suspension fluid
AHC
Under the unloaded condition, check
the suspension fluid AHC in the follow-
ing way.
1. Start the engine and put the vehicle
height in the "LO" (Low) mode and
then "N" (Normal) mode.
2. Turn off the ignition switch about 30
seconds after the "N" (Normal) mode
indicator light comes on.
3. Make sure the fluid level is between
"MAX" and "MIN".
If the fluid level is lower than "MIN", have
suspension fluid AHC filled by your Toyota
dealer.
318
NOTICE
Only use the Suspension fluid AHC
for the active height control suspen-
sion. If you fill other fluids such as
brake fluid, automatic transmission
fluid, power steering fluid, engine oil,
etc., the active height control suspen-
sion could be damaged.

Checking brake fluid

To check the fluid level, simply look at
the see- through reservoir. The level
should be between the "MAX"
"MIN" lines on the reservoir.
It is normal for the brake fluid level to go
down slightly as the brake pads wear or
when the fluid level in the accumulator is
high.
If the reservoir needs frequent refueling,
it may indicate a serious mechanical prob-
lem.
and