Toyota 2006 Land Cruiser Owner's Manual page 165

SYSTEM MALFUNCTION
If the low tire pressure warning light
blinks, it indicates a system malfunc-
tion. Contact your Toyota dealer.
The system will be disabled in the condi-
tions below:
D
Electric devices or facilities using simi-
lar radio wave frequencies are nearby.
D
If a radio set at similar frequencies is
in use.
D
Much snowflakes or ice gets on the
vehicle, in particular, around the wheels
or wheel housings.
D
Non- genuine Toyota wheels are used.
D
Snow tires or tire chains are used.
D
The sensor battery is expired.
D
The tires not equipped with tire pres-
sure sensor are used.
D
Radio waves from the air pressure sen-
sor installed on the spare tire cannot
be received.
D
Although the tires are equipped with
tire pressure sensors, the
switch (see page 154) is set to other
tire setting.
NOTICE
z The use of non- genuine wheels will
cause the tire pressure sensors to
transmit the electronic code in dif-
ferent manner, resulting in the fail-
ure of the system.
z The use of tires other
nally installed with genuine wheels
may also cause the malfunction of
the system.
selector
This device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions: (1) This device
may not cause harmful interference, and
(2) this device must accept any interfer-
ence received,
that may cause undesired operation.
than origi-
NOTICE:
This equipment has been tested and
found to comply with the limits for a
Class B digital device, pursuant to Part
15 of the FCC Rules. These limits are
designed to provide reasonable protec-
tion against harmful interference in a
residential installation. This equipment
generates, uses and can radiate radio
frequency energy and, if not installed
and used in accordance with the instruc-
tions, may cause harmful interference to
radio communications. However, there is
no guarantee that interference will not
occur in a particular installation. If this
equipment does cause harmful interfer-
ence to radio or television reception,
which can be determined by turning the
equipment off and on, the user is en-
couraged to try to correct the interfer-
ence by one or more of the following
measures:
including interference
151