Toyota 2006 Land Cruiser Owner's Manual page 175

NOTICE
z If you change the vehicle height fre-
quently, the pump may overheat. To
prevent this, the active height con-
trol suspension should be stopped
temporarily for a minute between
selections. Operate it again.
z Before you lower the vehicle height
with the height select switch, check
under the vehicle to make sure
nothing to damage the vehicle or
no one to be injured is there and
that the underbody of the vehicle
does not touch the ground.
z After unloading, the height of a ve-
hicle equipped with the
height control suspension becomes
slightly higher than the normal ve-
hicle height. Take sufficient care
where the overhead height is re-
stricted.
The vehicle height cannot be raised if
the vehicle load exceeds the following
limits:
D
Up to 4 occupants
(617 lb.) in the normal mode
D
Up to 4 occupants
(331 lb.) in the high mode
∗
: About 75 kg (165 lb.) for a person
If the above load capacity is exceeded,
the desired vehicle height may not be ob-
tained even if the height select switch is
pushed. (If the vehicle height cannot be
raised in the normal mode and the height
control indicator indicates "LO", this is be-
cause the vehicle is loaded too heavily.
Under these conditions, drive your vehicle
active
with due care.)
If the vehicle height cannot be raised
even after unloading, push the height se-
lect switch on the "
the " " side. If this does not work, turn
off the ignition once and then turn on.
Operate the select switch again.
If the vehicle height is adjusted on the
slope, or with the selector lever in a posi-
tion other than "P" or "N" while the vehicle
is stopped, you may hear a sound caused
by the expansion and contraction of the
propeller shaft.
Selecting the high mode—
Push the height select switch on the "
side when the vehicle speed is under
∗
plus about 280 kg
about 30 km/h (19 mph).
To change the normal mode to high,
∗
plus about 150 kg
push the switch once.
To change the low mode to high, push
the switch twice. It takes about 30 se-
conds until the low mode changes to the
high mode.
Selecting the normal mode—
To change the high mode to normal,
push the height select switch on the "
side once.
To change the low mode to normal,
push the height select switch on the "
side once.
Selecting the low mode—
" side and then on
Push the height control switch on the
" " side while the vehicle is stopped.
To change the high mode to low, push
the switch twice.
To change the normal mode to low,
push the switch once.
"
"
"
161