Custom Door Panels - Whirlpool 2210718 Use & Care Manual

Connecting to refrigerator:
1. Remove the shipping tape from gray, coiled water tubing on
the rear of the refrigerator.
2. Style 1: Thread the provided nut onto the coupling on the end
of the copper tubing. Tighten the nut by hand. Then tighten it
with a wrench two more turns. Do not overtighten.
Style 2: Thread the provided nut onto the water valve as
shown.
Tighten the nut by hand. Then tighten it with a wrench two
more turns. Do not overtighten.
3. Turn shut-off valve ON. Check for leaks. Tighten any nuts
or connections (including connections at the valve) that leak.
4. Plug in refrigerator or reconnect power.
5. Flush the water system (see the "Water System Preparation"
section).
NOTE: It may take up to 24 hours for your ice maker to begin
producing ice.

Custom Door Panels

Creating Custom Wood Panels
If you plan to install custom wood decorator panels, you will need
to create the panels yourself or consult your cabinet maker or
carpenter. See dimensional drawings for wood panel inserts.
Flat panels:
You can create a custom flat panel a maximum of ¹⁄₄ in. (6.35 mm)
thick to replace your decorator panels. Flat wood panels less
than ¹⁄₄ in. (6.35 mm) thick are not recommended.
Raised panels:
A raised panel design can be created by screwing or gluing wood
panels to ¹⁄₄ in. (6.35 mm) backing or by using ³⁄₄ in. (19.05 mm)
stock with routed edges. Raised panels should be spaced
2¹⁄₄ in. (5.70 cm) from the back edge of the handle to allow room
for fingers to grasp the handle.
Weight requirements for raised panel inserts:
Refrigerator door panel should not exceed 28 lbs.
(12.7 kg).
Freezer door panels should not exceed 21 lbs. (9.5 kg)
combined weight.
Dimensions for custom wood panels:
1/8"
(3.18 mm)
1/8"
(3.18 mm)
15 3/8"
(39 cm)
15 3/8"
(39 cm)
Installing Custom Wood Panels
1. Remove any packing tape.
2. Remove the refrigerator and freezer door trims from the hinge
side of each door by pulling the trim away from the bottom of
the door first.
3. Partially unscrew the two screws that hold the top trim in
place. It is not necessary to completely remove the screws.
Loosen the screws approximately ¹⁄₄ in. (6.35 mm) from the
trim to allow the panels to slide freely.
4. Remove the existing door panels, if panels were provided.
5. Slide custom door panels into place.
NOTE: The freezer door panels may require ¹⁄₈ in. (3.18 mm)
cardboard fillers behind the panels to keep them from being
loose in that area.
1/8"
(3.18 mm)
1/8"
(3.18 mm)
24 3/16"
(61.5 cm)
19 3/32"
(48.5 cm)
68 15/32"
(174 cm)
29 7/8"
(76 cm)
7