Samsung SCD-5083R User Manual page 27

y DaY/nighT : You can display pictures in color or in black and white.
❶ If the SPECIAL menu screen is displayed, use the Function Setup switch so
that the arrow indicates 'DAY/NIGHT'.
❷ Select a desired mode using the Function Setup switch according to the
picture display you want.
- auTo : The mode is switched
to 'Color' in a normal
environment, but switches
to 'B/W' mode when
ambient illumination is low.
To set up the switching
time for AUTO mode, press the Function Setup switch. You can turn
on or off the burst signal on B/W mode.
y BURST MODE : Activate or deactivate the burst mode to maintain or
y DURATION : This function is used to select the brightness of light where
switching occurs.
y DWELL TIME : You can select day/night switching delay time from.
M
`
If you set the AGC mode to off on the exposure menu, you cannot switch the day/night mode to auto.
`
When a bright light source is in the screen or there are frequent brightness changes, if you use the
auto night/day mode, and set the switching time to short (3, 5 sec), a hunting can be caused. In this
situation, it is recommended to use the default setting (30 sec).
- EXTERN : Ground to the grounding terminal to allow automatic switching between
COLOR and B/W (Black/White).
- COLOR : The picture is always displayed in color.
- B/W : The picture is always displayed in black and white.
y DEfog : You can use the defog mode to allow the camera to automatically
detect the fog density of the screen and display a clear image despite
smog, fog or general poor visibility.
❶MM I f the SPECIAL menu screen is displayed, use the Function Setup switch so that
the arrow indicates 'DEFOG'.
❷MM S elect a desired mode using the Function Setup switch.
- AUTO : Adjust the level automatically.
BURST MODE
▶ 1.
DURATION
2.
DWELL TIME
3.
RETURN
4.
remove the color signal.
→ 3s, 5s, 7s, 10s, 15s, 20s, 30s, 40s, 60s
AUTO SETUP
ON
NORMAL
30 SEC
English_27