Toyota 2007 Highlander Owner's Manual page 297

The ceiling mounted garage door opener
motor should now recognize
HomeLink R unit and be able activate the
garage door up/down.
4. Repeat steps 1 through 3 for each re-
maining HomeLink R button to program
another rolling code system.
Programming an entrance gate/program-
ming all devices in the Canadian market
1. Decide which of the 3 HomeLink
tons you want to program.
2. Place your hand−held gate/device
transmitter 25 to 75 mm (1 to 3 in.)
away from the surface
R
HomeLink .
Keep the indicator light on the HomeLink
in view while programming.
3. Press and hold the
HomeLink R button.
4. Continuously press and release (cycle)
the hand−held gate/device transmitter
button every two seconds until step 5
is complete.
5. When the indicator light
HomeLink R changes from a slow to a
rapid flash after 20 seconds, you can
release both buttons.
6. Test the operation of the HomeLink
pressing the newly programmed button.
the
Check to see if the gate/device oper-
ates correctly.
7. Repeat steps 1 through 6 for each re-
maining HomeLink R
another device.
Programming other devices
To program other devices such as home
R but- security systems, home door locks or
lighting, contact your authorized Toyota
dealer for assistance.
Reprogramming a button
of the
Individual HomeLink R
erased, however, to reprogram a single
R button, follow the procedure "Programming
the HomeLink R ".
selected (b) Operating the HomeLink
To operate the HomeLink
appropriate HomeLink R
the programmed device. The HomeLink
indicator light should
HomeLink R continues to send the signal
for up to 20 seconds as long as the
on the
button is pressed.
'07 HIGHLANDER HV_U (L/O 0608)
R by
button to program
(c) Erasing
buttons cannot be
memory (all three programs)
To erase all previously programmed codes
at one time, press and hold down the 2
outside buttons for 20 seconds until the
R
indicator light flashes.
R , press the
If you sell your vehicle, be sure to erase
button to activate
the programs stored in the HomeLink
R
memory.
come on. The
For additional programming assistance
with your
Transceiver call the:
Toyota Customer Experience Center at
D
1−800−331−4331 (U.S.A.)
Toyota
D
Centre at 1−888−869−6828 (Canada)
2007 HIGHLANDER HV from July '06 Prod. (OM48685U)
the entire HomeLink R
R
HomeLink R Universal
Canada Customer Interaction
285