Toyota 2007 Highlander Owner's Manual page 290

CALIBRATING THE COMPASS (circling
calibration)
Sometimes the direction display on the
compass may not change after a turn. To
rectify this, stop the vehicle and push and
hold the " " switch until "C" appears on
the display.
If "C" appears on the display because of
a drastic change in the magnetic field,
perform circling calibration.
278
'07 HIGHLANDER HV_U (L/O 0608)
Drive the vehicle in a circle at 8 km/h (5
mph) or less. If there is not enough space
to drive in a circle, drive around the
block.
After driving 1 to 3 circles in the above
method, calibration is completed when the
direction is shown on the display.
If calibration cannot be performed because
of the magnetized vehicle etc., take your
vehicle to Toyota dealer.
Perform circling calibration just after
you have purchased your Toyota. And
then always perform circling calibration
after the 12 volt battery has been re-
moved, replaced or disconnected.
Do not perform circling calibration of
D
the compass in a place where the
earth's magnetic field is subject to in-
terference by artificial magnetic fields
(underground parking, under a steel
tower, between buildings, roof parking,
near a crossing, near a large vehicle,
etc.).
During calibration, do not operate elec-
D
tric systems (moonroof,
dows, etc.) as they may interfere with
the calibration.
2007 HIGHLANDER HV from July '06 Prod. (OM48685U)
power win-