Toyota 2007 Highlander Owner's Manual page 199

AUDIO CONTROL (Tone and sound bal-
ance adjustment function)
Each time you push the
CONTROL" knob, the mode changes. To
adjust the tone and balance, turn the
knob.
BAS: Adjusts low−pitched tones. The dis-
play ranges from −5 to 5.
MID: Adjusts mid−pitched tones. The dis-
play ranges from −5 to 5.
TRE: Adjusts high−pitched tones. The dis-
play ranges from −5 to 5.
FAD: Adjusts the sound balance between
the front and rear speakers. The display
ranges from F7 to R7.
BAL: Adjusts the sound balance between
the right and left speakers. The display
ranges from L7 to R7.
DISC (Compact disc)
Push the "DISC" button to play a compact
disc.
When the audio system is set into com-
pact disc operation, the display shows the
track, or track and disc number currently
being played.
Vehicles with rear seat entertainment sys-
tem—
"AUDIO The "DISC" button may also be used to
operate a DVD player when a disc is
loaded in the DVD player. Pressing the
"DISC" button changes between the CD
player and DVD player. When the DVD
player is in operation, "AUX" appears on
the display.
Error messages
If the player malfunctions, your audio sys-
tem will display following error messages.
"WAIT": The compact disc player unit
may be too hot. Allow the player to cool
down.
"ERROR 1": The disc may be dirty, dam-
aged or inserted incorrectly
down). Clean the disc and re−insert it.
"NO DISC": The compact disc changer of
separate unit is empty. Insert a disc.
"ERROR 3": There is a problem inside
the system. Eject the disc or magazine.
Set the disc or magazine again.
"ERROR 4": Over−current.
Toyota dealer to inspect.
"CD OPEN": The compact disc changer
lid of separate unit is open. Close the
compact disc changer lid.
'07 HIGHLANDER HV_U (L/O 0608)
If the malfunction still exists, take your
vehicle to your Toyota dealer.
DISC
Use these buttons to select a disc you
want to listen to.
Push " " (preset button 3) or " " (preset
button 4) until the number of the disc you
want to listen to appears on the display.
Dolbyr
If you are listening to a tape that was
recorded with Dolbyr B Noise Reduction,
push " " (preset button 3). "
appear on the display. Push the button
again to turn off Dolbyr B NR.
The Dolby NR mode reduces tape noise
by about 10 dB. For best sound reproduc-
(up−side
tion, play your tapes with this button on
or off according to the mode used to re-
cord the tape.
∗
: Dolby noise reduction manufactured under license from
Dolby Laboratories Licensing Corporation. "DOLBY" and the
double D symbol
Licensing Corporation.
FM
Ask your
Push the "FM" button to turn on the radio
and select the FM band. "FM1" or "FM2"
will appear on the display. This system
allows you to set twelve FM, two for each
of the preset button.
2007 HIGHLANDER HV from July '06 Prod. (OM48685U)
∗
B NR
" will
are trademarks of Dolby Laboratories
187