Installation Of Battery; Electrical Requirements - Tommy Bahama PARADISE KEY TB301MAB01 Owner's Manual

Preset Memory Feature
Your Tommy Bahama receiver is equipped
with a preset memory feature. If the AC sup-
ply to the receiver is powered through a wall
switch, when the switch is turned OFF, the
control will remember the light intensity and
fan speed. When the switch is turned back ON
the light and fan will resume operation as they
were prior to the switch being turned OFF.

Installation of Battery

1. Remove the battery cover by pressing firm-
ly below the arrow and sliding the cover off
the control (Figure 1).
2. Remove the connector from the battery
compartment and install two AAA alkaline
batteries.
TWO AAA
BATTERIES
BATTERY
COMPARTMENT
COVER
Figure 1
Installation of Storage
Bracket
A storage bracket is provided for holding your
remote control when not in use. If you desire
to use the bracket, install it on a wall that is
away from excess heat or humidity (Figure 2).
TO INSTALL BRACKET TO WALL:
SLIDE THE COVER UP TO EXPOSE THE SCREW
HOLES FOR INSTALLATION
COVER
WALL
BRACKET
SCREW
HOLES (2)
Figure 2
CODE
SWITCHES
TBSR600 REMOTE
CONTROL
5
CEILING FAN PROCEDURES

Electrical Requirements

IMPORTANT: Your ceiling fan will not
function properly, and may be damaged,
if used with any wall dimmer switch or
control other than the Tommy Bahama
TBSR600 Fan/Light Remote Control
supplied with the fan.
Your new ceiling fan will require a grounded
electrical supply line of 120 volts AC, 60 Hz,
15 amp circuit.
The outlet box must be securely anchored and
capable of withstanding a load of at least 50
pounds.
WARNING
!
To reduce the risk of fire, electric shock, or
personal injury, mount fan to outlet box
marked "Acceptable for Fan Support of
22.7 kg. (50 lbs.) or less", and use screws
supplied with outlet box. Most outlet boxes
commonly used for support of light fix-
tures are not acceptable for fan support
and may need to be replaced. Consult a
qualified electrician if in doubt.
If your fan is to replace an existing ceiling light
fixture, turn electricity off at the main fuse or
circuit breaker box at this time and remove the
existing light fixture.
WARNING
!
Turning off wall switch is not sufficient. To
avoid possible electrical shock, be sure
electricity is turned off at the main fuse or
circuit breaker box before wiring. All
wiring must be in accordance with
National and Local codes and the ceiling
fan must be properly grounded as a pre-
caution against possible electrical shock.
WARNING
!
To avoid possible fire or shock, follow all
wiring instructions carefully.
Any electrical work not described in these
instructions should be done or approved
by a licensed electrician.