Table of Contents
Advertisement
Operating in a high altitude environment
We recommend you use the High Altitude Mode when your environment is between
1500 m –3000 m above sea level, and ambient temperature is between 0°C–35°C.
Do not use the High Altitude Mode if your altitude is between 0 m and 1500 m and ambient
temperature is between 0°C and 35°C. The projector will be over cooled, if you turn the mode
on under such a condition.
To activate the High Altitude Mode:
1.
Press Menu/Exit and then press
is highlighted.
2.
Press
confirmation message displays.
3.
Highlight Yes and press Mode/Enter.
Operation under "High Altitude Mode" may cause a higher decibel operating noise level
because of increased fan speed necessary to improve overall system cooling and
performance.
If you use this projector under other extreme conditions excluding the above, it may
display auto shut-down symptoms, which is designed to protect your projector from
over-heating. In cases like this, you should switch to High Altitude mode to solve these
symptoms. However, this is not to state that this projector can operate under any and all
harsh or extreme conditions.
Locking control keys
With the control keys on the projector locked, you can prevent your projector settings
from being changed accidentally (by children, for example). When the Panel Key Lock is
on, no control keys on the projector will operate except
1.
Press
go to the SYSTEM SETUP: Basic > Panel Key Lock
menu, and select On by pressing
projector or remote control. A confirmation
message is displayed.
2.
Highlight Yes and press Mode/Enter to confirm.
To release panel key lock, press and hold
remote control or projector for 3 seconds.
You can also use the remote control to enter the
menu and press
•
Keys on the remote control are still active when panel key lock is enabled.
•
If you press
projector will still be in locked status the next time it is turned on.
40
Operation
to highlight High Altitude Mode and press
/
on the projector or remote control or
/
to select
I
Power to turn off the projector without disabling panel key lock, the
I
/
until the SYSTEM SETUP: Advanced menu
/
on the
/
on the
SYSTEM SETUP: Basic >
.
Off
/
select On. A
I
I
Power.
Panel Key Lock
Advertisement
Table of Contents
