Step 4 - Closing The Housing; Step 5 - Final Check - Ikelite 6184.99 Instruction Manual

STEP 4 - Closing the Housing

1. Once the back is properly
installed, the o-ring should touch
the housing all the way around.
There should be an even gap on
each side of the housing between
the housing and the back.
2. Lift the lid snaps so they are
extended and place each lid snap
into the corresponding hook on
the housing back.
3. To close the housing, push down on
the opposing lid snaps simultaneously
until they snap into place. Be sure
they are down far enough to engage
the Lid Snap Lock. The o-ring seal
should now appear as a solid black
line from the back of the housing.

STEP 5 - Final Check

The clear housing permits instant visual inspection of the camera and
sealing surfaces as well as complete monitoring of controls and camera
LCD screens. This housing has been factory water pressure tested to
200 ft (60 m).
Once the camera is properly installed and the housing is closed, recheck
the o-ring seal. Double check the gap between the housing back and the
housing. It should be even all the way around the housing.
Look through the clear plastic back at the o-ring. You should see a
darkened area or solid black line where the o-ring is compressed against
the housing back. If you do not see an even black compression seal all
the way around the back, open the lid snaps, reseat the housing back and
close the lid snaps. Visually check the seal again.
Lid Hook
Even gap on
all four sides
Lid
Snap
Lid Snap Lock
Housing Back
O-ring
11