Installation; Operating Your Wine Cooler - Vinotemp VT-140TSBW Owner's Manual

Dual-zone/approx 142 bottles
Table of Contents

Advertisement

Remove all packing material before using your wine cooler.
IMPORTANT: Before connecting the unit to a power source, let it stand upright for approximately 24
hours. This will reduce the possibility of a malfunction in the cooling system from handling during
transportation.
Clean the interior surface with lukewarm water and a soft cloth.
This unit is designed for freestanding or built in installation and indoor use only. Position the unit in a
dry and well-ventilated place. Avoid placing the wine cooler near any source of heat or moisture, or in
direct sunlight. Do NOT install the unit in a location with an ambient temperature that will fall below
60°F.
For freestanding installation, 5" of space at the back and on each side of the wine cooler are
suggested to ensure proper air circulation to cool the compressor and condenser. Even for built-in
installation, it is recommended that you keep ¼" of space on each side and at the top of the cooler to
ensure proper service access and ventilation. Do not cover or block the front air vent in any way.
Place the wine cooler on a level surface strong enough to support it when it is fully loaded. To level
the wine cooler, adjust the front leveling legs at the bottom of the wine cooler.
For best performance it is recommended that you install the appliance in a location with an
ambient temperature between 60°-90°F. If the ambient temperature is above or below
recommended temperatures, the performance of the unit may be affected.
Plug the wine cooler into an exclusive, properly installed-grounded wall outlet.

OPERATING YOUR WINE COOLER

CONTROLS
Power
To turn the appliance ON or OFF, touch the
Set
Set or view the internal temperature setting for each zone.
Light
Turn the inner light ON or OFF.
Up
Raise the set temperature by 1°C or 1°F.
Down
Lower the set temperature by 1°C or 1°F.
ºF/ºC Selector
Choose to display temperature setting in Fahrenheit or Celsius. To change the temperature display from
Fahrenheit to Celsius or from Celsius to Fahrenheit, touch and hold
Key Lock
After 2 minutes of inactivity, the controls will be locked automatically. To release the lock, touch the
and
at the same time for 5 seconds.
1 7 6 2 1 S o u t h S u s a n a R o a d , R a n c h o D o m i n g u e z , C a l i f o r n i a 9 0 2 2 1

INSTALLATION

and
at the same time for 5 seconds.
i n f o @ v i n o t e m p . c o m
for 5 seconds.
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents