Power Management Setup Page - ECS P41G Series User Manual

Power Management Setup Page

This page sets some parameters for system power management operation.
CMOS Setup Utility – Copyright (C) 1985-2005, American Megatrends, Inc.
ACPI Suspend Type
Soft-off by PWR-BTTN
PWRON After PWR-Fail
Resume By RING
Resume by PCI/PCI-E/Lan PME
Resume By USB (S3)
Resume By PS2 KB (S3)
Resume By PS2 MS (S3)
Resume on RTC Alarm
: Move Enter: Select +/-/: Value
F1: General Help
ACPI Suspend Type
Use this item to define how your system suspends. In the default, S3 (STR), the
suspend mode is a suspend to RAM, i.e., the system shuts down with the
exception of a refresh current to the system memory.
Soft-off By PWR- BTTN
If the item is set to Instant-Off, then the power button causes a software power
down. If the item is set to Delay 4 Sec. then you have to hold the power button
down for four seconds to cause power down.
PWRON After PWR-Fail
This item enables your computer to automatically restart or return to its last
operating status.
Resume By Ring
The system can be turned off with a software command. If you enable this item,
the system can automatically resume if there is an incoming call on the Modem.
You must use an ATX power supply in order to use this feature.
Resume by PCI/PCI-E/Lan PME
This item specifies whether the system will be awakened from power saving
modes when activity or input signal of the specified WOL device is detected.
Resume By USB (S3)
This item allows you to enable or disable the USB device wakeup function from
S3 mode.
Chapter 3: BIOS Setup Utility
Power Management Setup
S3
Delay 4 Sec
Power Off
Select the ACPI
Disabled
state used for
Disabled
System Suspend.
Disabled
Disabled
Disabled
Disabled
F10: Save Esc: Exit
F9: Load Default Settings
27
Help Item