Advertisement
Contents
Connections
Symptom
DTS Neo:X mode cannot
It cannot be selected when "Speaker Config." - "Surround" is set for "None".
0
be selected.
DTS Neo:X cannot be selected when using the headphones.
0
Dolby Surround mode
Dolby Surround cannot be selected when using the headphones.
0
cannot be selected.
Audyssey MultEQ
®
XT32,
These cannot be selected when you have not performed Audyssey
0
Audyssey Dynamic EQ
®
,
Switch to a sound mode other than "Direct" or "Pure Direct".
0
Audyssey Dynamic
These cannot be selected when using the headphones.
0
Volume
®
and Audyssey
LFC™ cannot be selected.
It can be selected when using the front height or front wide speakers.
Audyssey DSX
®
cannot be
0
selected.
It can be selected when using the center speaker.
0
Switch the sound mode to Dolby sound mode or DTS sound mode.
0
This cannot be selected when using the headphones.
0
This cannot be set when the input signal is a 2-channel source.
0
"M-DAX" cannot be
Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of
0
selected.
multichannel signals such as Dolby Digital or DTS surround, "M-DAX" cannot be used.
Switch to a sound mode other than "Direct" or "Pure Direct".
0
No audio is output from
In ZONE2/ZONE3, the audio can be played back when signals input from digital connectors (OPTICAL/
0
PRE OUT or speakers for
COAXIAL) are in 2ch PCM format.
ZONE2/ZONE3.
In ZONE2, the audio can be played back when signals input from the HDMI connector are in 2ch PCM
0
format. To play back the audio in ZONE2 irrespective of the input signal format, set "HDMI Audio" in the
menu to "PCM". Depending on the played back device, the audio may not be played back even with this
setting. In that case, set the audio format to "PCM (2ch)" on the played back device.
When listening to audio from a Bluetooth device in ZONE2/ZONE3, remove any obstructions between the
0
Bluetooth device and this unit and use it within a range of about 32.8 ft/10 m.
Front panel
Display
Playback
Settings
Cause / Solution
Rear panel
273
Tips
®
Setup.
Remote
Index
Appendix
Page
224
－
－
203
139
－
225
224
138
－
－
178
139
－
243
－
Advertisement
