Selecting The Language For Osd; Screen Saver; Delay Time (Center/Rear); Test Tone - Teac PL-D2100 Owner's Manual

Settings (General Setup)

Selecting the Language for OSD

-- GENERAL PAGE --
TV DISPLAY
TV TYPE
VIDEO OUTPUT
ANGLE MARK
OSD LANG

SCREEN SAVER

MAIN PAGE
SET OSD LANGUAGE
You can select the language for OSD (On Screen Display). This
setting allows you select a preferred language for the SETUP
menu and operating messages. The default language is
ENGLISH.
Screen Saver
-- GENERAL PAGE --
TV DISPLAY
TV TYPE
VIDEO OUTPUT
ANGLE MARK
OSD LANG
SCREEN SAVER
MAIN PAGE
SCREEN SAVER SETTING
Turns on or off the screen saver.
If you turn on the screen saver, the screen saver image
appears when you leave the system in pause or stop mode for
1 minute. The screen saver is useful to prevent your display
from becoming damaged.
The default setting is "OFF".
28
ENGLISH
FRENCH
GERMAN
ITALIAN
SPANISH
OFF
ON
Settings (Speaker Setup)
Delay Time (Center/Surround)
-- SPEAKER SETUP PAGE --
CENTER DELAY 5MS
SURROUND DELAY

TEST TONE

3MS
MAIN PAGE 1MS
OFF
SET CENTER DELAY
If the speakers cannot be placed at the same distance from
your listening position, adjust the delay time to improve the
surround effect.
The delay time of 1MS corresponds to 30 cm.
Adjustable range
Center: 0MS(OFF) to 5MS
Surround: 0MS(OFF) to 15MS in 3MS steps
For example, if the center speaker is closer to the listening
position than the front speakers by about 90cm, set the
CENTER DELAY to 3MS.
< You cannot adjust delay time when the listening mode is set to
LT/RT, STEREO or VSS. In this case, press the SETUP button to
exit the setup menu, press the LISTENING button repeatedly to
select PRO LOGIC, and then press the SETUP button again.
< The delay time for the front speaker and the subwoofer isn't
available.
< Delay time setting will not work properly when the center or
surround speaker is farther than others.
Test Tone
-- SPEAKER SETUP PAGE --
CENTER DELAY
REAR DELAY
TEST TONE
MAIN PAGE
TEST TONE
ON:
Test tone is emitted from each speaker at 2.5-second intervals.
You can use the test tone to check if the speakers are
connected properly.
OFF (default):
Test tone is off.
-- SPEAKER SETUP PAGE --
CENTER DELAY
SURROUND DELAY 15MS
TEST TONE
9MS
MAIN PAGE
3MS
OFF
SET SURROUND DELAY
ON
OFF