Channel Level; Sleep Timer; Reset Button - Teac PL-D2100 Owner's Manual

Channel Level

1 Press the SELECT button.
Each time the SELECT button is pressed, the channel is
changed as follows:
TRE BAS
SUB SL
FL: Front Left speaker
CNT: Center speaker
FR: Front Right speaker
SR: Surround Right speaker
SL: Surround Left speaker
SUB: subwoofer
< When the listening mode is set to LT/RT, STEREO or VSS, the
center and surround speakers (CNT, SR, SL) will not appear on
the display (see page 16).
2 Within 3 seconds, press the VOLUME buttons to change the
level.
< The level of speakers can be adjusted in 1 dB steps from -15
dB to +10 dB. The default setting is 0 dB.
Repeat step 1 and 2 to change other settings.
When all the configurations have been finished, leave the unit
idle for 3 seconds to exit the Channel Select mode.

Reset button

If you press the RESET button, the following settings will be
reset to the factory defaults:
Volume, Tone Control, Channel level of speakers
FL CNT
SR FR
EEPS (Electronic Equalizer Preset System)
The EEPS button offers rock, pop, jazz and classic modes to
enhance your listening.
Each time the EEPS button is pressed, the mode is changed as
follows:
CLASSIC (flat)
Muting
To mute the sound temporarily, press the MUTING button.
Press the MUTING button again to restore the sound. If you
change the volume during the muting, the muting will be
cancelled.

Sleep Timer

The power can be switched off after a specified amount of
time.
Press the SLEEP button repeatedly until desired time appears
on the display.
The sleep time can be changed by 10 minutes' step.
120 MIN (110, 100...or 10)
The SLEEP indicator lights, and the power will be switched off
120 (110, 100...or 10) minutes later.
OFF
Sleep timer is off.
< If you want to check the remaining time, press the SLEEP
button once. The remaining time will be displayed for 3
seconds, and return to the normal display.
ROCK POP JAZZ
15