Fan Mode; Flap Control; Sense Here Function - Tadiran Telecom TGI-07H Technical Manual

Tgi series
Hide thumbs Also See for TGI-07H:
Table of Contents

Advertisement

9. CONTROL MODE

8. Fan mode

When select the fan mode , only both the indoor fan and flap operate in a preset
mode . If the fan speed is set to automstic , the fan runs at the low speed.

9. Flap control

9.1 Press the up and down flap button , the flaps position is switched over
between the 8 statuses , i.e automatic flap , flap orientation where the flap
plate opens to 6 positions 1,2,3,4,5,6 from down to up , and flap swing .
9.2 Automatic flap : In heating mode , the flap swings between position 1 and
position 4 . In Cooling or Dry mode , the flap swings between position 3 and
position 6 . In Fan mode the flap is located at top position 5.
9.3 Flap orientation : The flap is set at a certain position by using the remote
controller.
9.4 Flap swing : The flap swings between position 1 and position 6.
9.5 The default status is the automatic flap.
9.6 When powered on and off for the first time , the flap plate turns to the
maximum angle to ensure that the flap is closed ; When the unit starts , the
flap plate moves to the maximum angle , and returnes to the preset position
after the flap is completely closed.
10.

Sense here function

10.1
The indoor control unit has two thermal for detecting the room
temperatures , one is installed in the remote controller , and the other at the
air intake of the indoor unit . The default air outlet settings is subject to the
remote controller's detection .The remote controller detects the room
temperature every 20 seconds , and automatically transmits the signal at 3
minutes intervals or when it has detected a change in the room temperature .
If the indoor control unit has not received a remote signal for more than 10
minutes , the control function will be automatically switched over to the
temperature sensor at the air intake .
10.2
Neither turning on nor turning off operation will cancel the interface
communicatin function.
10.3
In default , the airconditioner is set to start the interface communication
function.
35

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Tgi-18hTgi-09hTgi-12h

Table of Contents