Table of Contents
Advertisement
Electrical connection
Warning! This hob must be earthed.
Electrical requirements
Any permanent electrical installation must
comply with the latest I.E.E. Regulations and
local Electricity Board regulations. For your
own safety this should be undertaken by a
qualified electrician, e.g. your local Electricity
Board, or a contractor who is on the roll of
the National Inspection Council for Electrical
Installation Contracting (NICEIC).
Electrical connection
The hob is designed to be connected to 230
V (50 Hz) electricity supply. Before
connecting to the mains supply ensure that the
mains voltage corresponds to the voltage on
the rating plate underneath the hob.
For UK only
It is necessary that you install a double pole
switch between the hob and the electricity
supply (mains), with a minimum gap of 3 mm
between the switch contacts and of a type
suitable for the required load in compliance
with the current rules.
Warning! The switch must not break
the yellow and green earth cable at any
point. It is necessary that the yellow /
green earth wire is about 2 cm longer
than the live and neutral ones.
Important! After installation and
connecting, the cable must be placed so that
it cannot at any point reach a temperature of
more than 60°C above the ambient
temperature.
Before the hob is connected, check that the
main fuse and the domestic installation can
support the load; and that the power supply
is properly earthed.
The manufacturer disclaims any responsibility
should these safety measures not be carried
out.
15
Advertisement
Table of Contents
