Table of Contents
Advertisement
To Set A Desired Speed
Turn the Electronic Speed Control ON. When the vehicle has reached the desired speed, move the
electronic speed control lever upward SET(+) and release. Release the accelerator and the vehicle
will operate at the selected speed.
NOTE:
The vehicle should be traveling at a steady speed and on level ground before moving the electronic
speed control lever upward SET(+).
To Deactivate
A soft tap on the brake pedal, pushing the RESUME/CANCEL button, or normal brake pressure
while slowing the vehicle will deactivate Electronic Speed Control without erasing the set speed
memory. Rotating the end of the multifunction lever to the "O" position or turning the ignition switch
OFF erases the set speed memory.
To Resume Speed
To resume a previously set speed, push the RESUME button and release. Resume can be used at
any speed above 18 mph (30 km/h).
To Vary The Speed Setting
To Increase Speed
When the Electronic Speed Control is set, you can increase speed by tapping the Speed Control
lever up (+).
The speed increment shown is dependant on the speed of U.S. (mph) or Metric (km/h) units:
U.S. Speed (mph)
• Tapping the Speed Control lever up (+) once will result in a 1 mph increase in set speed. Each
subsequent tap of the lever results in an increase of 1 mph.
• If the lever is continually help up, the set speed will continue to increase until the lever is
released, then the new set speed will be established.
Metric Speed (km/h)
• Tapping the Speed Control lever up (+) once will result in a 2 km/h increase in set speed. Each
subsequent tap of the lever results in an increase of 2 km/h.
• If the lever is continually help up, the set speed will continue to increase until the lever is
released, then the new set speed will be established.
O P E R A T I N G Y O U R V E H I C L E
27
Advertisement
Table of Contents
