Kohler COMMAND CV11-16 Service Manual page 91

Figure 8-48. Delco-Remy Solenoid Shift Starter.
Inspection
Drive Pinion
Check and inspect the following areas:
a. The pinion teeth for abnormal wear or
damage.
b. The O.D. surface between the pinion and the
clutch mechanism for nicks or burrs which
could cause seal damage.
c. Check the drive clutch by holding the clutch
housing and rotating the pinion. Pinion should
rotate in one direction only.
Collar
Ring
Stop
Drive
Armature
Washer
Tube
Electrical System and Components
Screw
Plunger
Spring
Lever
Plate
Plug
Solenoid
Frame & Field
Brush Holder
Nut
CE Frame ASM
Screw
Bolt
Brushes and Springs
Inspect both the springs and brushes for wear, fatigue,
or damage. Measure the length of each brush. The
minimum length for each brush is 7.6 mm (.300 in.).
See Figure 8-49. Replace the brushes if they are
worn undersize, or their condition is questionable.
Wear limit length:
7.6 mm (.300 in.)
Figure 8-49. Checking Brushes.
Section 8
8
8.31