Kohler COMMAND CV11-16 Service Manual page 106

Section 9
Disassembly
1. Check if the extra retaining clips are present.
If so, cut the clips, so they can be removed
and discard. Mark the tops of the knobs where
they were located. Order 3 new clips, Part No.
24 018 03-S, for installation during reassembly.
2. Remove the screen by unsnapping it from the
fan. See Figure 9-32.
Unsnap Grass
Screen from Fan
Figure 9-32. Removing Plastic Grass Screen.
3. Remove the fl ywheel from the crankshaft using a
puller. See Figure 9-33.
NOTE: Always use a puller to remove the
fl ywheel from the crankshaft. Do not
strike the crankshaft or fl ywheel, as
these parts could become cracked or
damaged.
Flywheel Puller
Figure 9-33. Removing Flywheel with a Puller.
4. Remove the four hex. fl ange screws, spacers,
and fan from fl ywheel. See Figure 9-34. Later
engines will have shoulder screws and no
spacers.
9.10
Fan
Figure 9-34. Removing Fan from Flywheel.
Fan
Remove the Stator and Wiring Harness
1. Remove the stator leads from connector body.
2. Remove the hex. fl ange screw and clip securing
3. Remove the hex. fl ange screw and clip securing
Hex. Socket
Screws (4)
Stator
Figure 9-35. Removing Stator.
Remove Oil Pan
1. Invert the engine, so the PTO end of crankshaft is
Strap Wrench
2. Remove the twelve hex. fl ange screws securing
Hex. Flange Screws (4)
the stator leads to the crankcase. See
Figure 9-35.
the kill lead to the crankcase. Remove the four
hex. socket head screws and stator.
Hex. Flange
Screw and Clip
up.
the oil pan to the crankcase. See Figure 9-36.
Spacers (4)
Flywheel
Stator Leads
Kill Lead