Kohler COMMAND CV11-16 Service Manual page 143

Mounting Screws
and Washers
Ground Lead
Figure 11-59. Installing Rectifi er-Regulator (not on
all models).
Install Fuel Pump (If So Equipped)
1. Install the rubber line and two hose clamps to the
fuel pump end of the metal fuel line. Secure the
rubber fuel line to the steel fuel line with one of
the clamps. See Figure 11-60.
Hex. Flange Screws
Gasket
Figure 11-60. Installing Fuel Pump.
2. Install the gasket, fuel pump, and two hex. fl ange
screws. Torque the screws as follows:
Into new as-cast hole–9.0 N·m (80 in. lb.).
Into used hole–4.2-5.1 N·m (37-45 in. lb.).
3. Install the opposite end of the rubber line to the
outlet fi tting of the fuel pump. Secure the fuel line
to the outlet fi tting with the other hose clamp.
Install Carburetor and External
Governor Components
1. Install the rubber fuel line and secure the rubber
fuel line to the metal fuel line with a hose clamp.
2. Install the bushing and attach the throttle linkage
to the carburetor throttle lever. See Figure 11-61.
Rectifi er-
Regulator
Bushing
Connector
Carburetor
Figure 11-61. Installing Carburetor and External
Governor Components.
3. Install the gasket and carburetor onto the intake
studs. Install the free end of the rubber fuel line
to the carburetor inlet fi tting. Secure the fuel line
Pump Outlet
with the other hose clamp. See Figure 11-62.
Fuel Line
Fuel Pump
Carburetor
Figure 11-62. Installing Gasket, Carburetor and
Fuel Line.
Throttle Linkage
Fuel Line
Governor Arm
Gasket
Throttle Linkage
Section 11
Reassembly
11
Fuel Line
11.19