Sony KDS-R50XBR1 Training Manual page 40

TVP-21
Access & Removal of Q -Box & PD-Board (cont.)
(Digital Module Block DMB )
Screws
Pull wire out to
access connector
Disconnected Wires
Disconnected
Wires
Unscrew
RF-connector
Peel Back tape
custom
5
Remove 6 screws to free the Q -
Box assembly.
Firmly grasp the assembly at the
top and bottom and pull to
dislodge it from the chassis
frame.
CAUTION: Be carefully not to pull
too far out and damage the wires
still connected.
6
Disconnect all cables on the Q-
Box module except for the
CableCard ribbon cable. This
cable remains apart of the Q -
Box.
NOTE: Reattach all wires
before securing the
replacement Q-Box to the
chassis assembly.
Disconnected
Wires
Disassembly Procedures
37