Rear & Sub Plastic Cover Removal - Sony KDS-R50XBR1 Training Manual

Rear & Sub Plastic Cover Removal
TVP-21
Rear and Sub Plastic Cover Removal & ASU-Board Access
Screws
Screws
Disconnect
fan cable
behind cover
Screws
Shields
Bracket
Release Wire Tie
CN2006
CN2010
CN2100
1
Remove 9 screws and pull rear
plastic cover straight back and
off.
Remove 5 screws and detach
AC cord from the slot . Pull sub
2
Detach
plastic cover slowly straight
AC Cord
back and off.
NOTE: Be careful of fan wire
and connector behind sub-
cover. Disconnect fan cable to
completely remove cover.
3
Remove 4 screws and release
the one wire tie. Slide the
bracket up slightly and pull off.
Disconnect the S1-Board
Remove both shields to access
the ASU-Board.
S1-Board
4
The ASU-Board can be probed
for troubleshooting at this point
of the disassembly process. It
can not be remove at this point .
Reference "ASU & G-Board
Removal" section.
Disassembly Procedures
26