Onkyo DV-SP800 Service Manual page 73

QQ
3 7 63 1515 0
UPGRADE FIRMWARE-9
Setting the ID number.
1. Input the ID number recorded before using the number button. (Refer to "
Number key
1,2 - - - 8,9,0
2. Press the SEARCH
SEARCH
ID data setting
1. Press the open/close button of the unit and the
tray is pulled out.
2. Load the ID data disc.
TE
L 13942296513
3. Press the open/close button and tray is closed.
The read-in work of ID data from
CDR starts automatically.
CLEAR
5
4. Check being displayed as "
5. Press the CLEAR button of remote controller and setting mode is ended.
www
6. Put out the disc.
7. Check the ID number.
.
8. Check the Firmware.
http://www.xiaoyu163.com
button.
Rom Write OK"
x ao u163
y
i
http://www.xiaoyu163.com
2 9
8
Check ID number"
TV Monitor
[Player's ID Number Setting]
ID Number?
> 0 0 0 0 0 0 0 0 1 OK?
<PLAY> Complata Mode
<SEARCH> Enter
Input ID Number !
[Player's ID Number Setting]
<CLEAR> Exit
Insert the ID Disc !
TV Monitor
[Player's ID Number Setting]
Q Q
3 6 7 1 3 1 5
Loading The ID data Disc !
[Player's ID Number Setting]
Loading The ID data Disc !
[Player's ID Number Setting]
Rom Write OK !
<CLEAR> Exit
co
.
9 4 2 8
)
FL display
IN ID DATA
If ID number is set up, it will
be in ID data input state from CDR.
FL display
RD ID DATA
0 5 8 2 9 9 4 2 8
It becomes such a display
during reading of data from
CDR.
WR ID DATA
If reading completes ID data
from CDR, next, the writing
of ID data to the flash ROM
of a set will start.
ID DATA OK
If the writing of ID data to a flash
ROM is completed, it will be
displayed as " Rom Write OK! "
m
DV-SP800
9 9
9 9