Appliance Preparation - Heatilator ODYSSEY ODY42 Installation & Operating Instructions Manual

1. Log Set
Unwrap the top right log shipped inside the valve
compartment and position over pins in proper location. See
Figure 35. The log set should look similar to that in Figure 26.
2. Place the Lava Rock and Vermiculite
Place lava rock on top of control access panel, in front of,
under and around burner. See Figure 27. When placing
the vermiculite, sprinkle it evenly over the area covered
by the lava rock. See Figure 28. It is not necessary to use
all of the lava rock. Save the remainder for future use.
24
ODYSSEY SERIES FIREPLACE WITH GAS LOG SET
I. APPLIANCE PREPARATION
31818 Rev J
3. Place the Rock Wool
Place approximately 1/2” diameter pieces of rock wool
under the front logs, on the bottom hearth log. Place the
rock wool the full length of the burner. Do not pack the
wool tightly against the burner. This appliance is supplied
with two bags of rock wool. It is not necessary to use all
of the wool. Save the remaining amount for future use.
See Figure 29.
4. Place the Fire Glow
Fire glow (Fire 98) is a flame colorant material that also
adds to the realism of the gas fireplace flame. After placing
the rock wool in the appliance, sprinkle some of the fire
glow (Fire 98) on top of the hearth log and rock wool. As
with the lava rock, vermiculite and rock wool, it is not
necessary to use the entire bag. Save the remaining for
future use. See Figure 30.
01/04