Disassembly Procedure - Yamaha EMX5000-12 Service Manual

DISASSEMBLY PROCEDURE

1. Panel Assembly (Time required: about 5 minutes)
1-1. Remove the six (6) screws marked [30a] and six (6)
screws marked [30b], and then remove the side pads
R and L. (Fig. 1)
1-2. Remove the four (4) screws marked [160a], four (4)
screws marked [160b], three (3) screws marked
[170a] and four (4) screws marked [170b] (three (3)
for EMX5000-12), Then lift the front end of the panel
assembly, turn it about 45° and remove the panel
assembly by releasing it from the claws on its side.
(Fig. 1)
This mark urges servicemen to pay attention.
[30b]
[160b]
[30b]
IN8
EMX5000-20 only
[170b] EMX5000-12
[30]: Bind Head Tapping Screw-B 4.0X8 MFZN2BL (EG340190)
[70]: Bind Head Tapping Screw-B 3.0X12 MFZN2BL (VQ074600)
[160]: Bind Head Tapping Screw-B 3.0X6 MFZN2BL (EP600230)
[170]: Bonding Tapping Screw-B 4.0X8 MFZN2BL (VR779900)
[70]
IN16 MAS
Fig.1
EMX5000-12/20
[170a]
[30a]
[160a]
[170b] EMX5000-20
[30a]
15