Panasonic KX-TG6811NZ Operating Instructions Manual page 33

R The handset does not beep when
cancelling its own registration.
4
MeN
Increasing the range of the base
unit
You can increase the signal range of the base
unit by using a DECT repeater. Please use
only the Panasonic DECT repeater noted on
page 5. Contact your Panasonic dealer for
details.
Important:
R Before registering the repeater to this base
unit, you must turn the repeater mode on.
R Do not use more than one repeater at a
time.
Setting the repeater mode
1
M N#138
2
MbN: Select the desired setting. a MOKN
a MeN
Note:
R After turning the repeater mode on or off,
may be displayed on the handset
momentarily. This is normal and the
handset can be used once
Registering the DECT repeater
(KX-A405) to the base unit
Note:
R Please use a repeater that has not yet been
registered to another unit. If the repeater is
registered to another unit, deregister it first,
referring to the Installation Guide for the
DECT repeater.
1
Base unit:
Proceed with the operation for your model.
n KX-TG6811 series: page 3
Press and hold M
seconds. (No registration tone)
n KX-TG6821 series: page 3
Press and hold M
seconds, until the registration tone
sounds.
PNQX5803YA_0719_ver122.pdf
2
3
is displayed.
N for about 5
N for about 5
33
Programming
R The next step must be completed
within 90 seconds.
DECT repeater:
Connect the AC adaptor, then wait until
the indicator and indicator light
green.
Base unit:
To exit the registration mode, press M
R The registration tone stops.
(KX-TG6821 series: page 3)
N.
33
2013/07/19 10:53:44