Table of Contents
Advertisement
Observe the correct polarity!
Connect the like-coloured terminals with one
another. Otherwise, the sound quality will
suffer. The cores of the speaker cable are marked with
different colours or shapes.
Split the cables down to approximately 30 mm on both
ends and strip approximately 10 mm of insulation on the
respective cores. Twist the cables so that no cores are
protruding.
Push down the lever for the connector terminal 11 on the
satellites and insert the stripped cable end into the open-
ing below the respective connector terminal. The cable is
clamped in place when the lever is released.
If you use banana plugs, screw the cord into place on
the plug (see instructions for the banana plug) and insert
the plug into the jack of the connector terminal 6 on the
subwoofer.
If you don't use any banana plugs, turn the connector
terminal 6 counterclockwise. Insert the stripped cable end
into the hole that is now visible. Turn the terminal clock-
wise. This will clamp the cable in place.
RCA input
You can connect almost any audio source to the RCA
jacks 4 "LINE IN" such as a computer, MP3 player (with/
without dock), video game system, television etc. The
source device only needs an output with line level. Such
outputs are configured either as stereo RCA jacks or as
a 3.5 mm jack plug. Connect such devices to the jacks
4 "LINE IN" using a corresponding connector cable. You
can purchase such cables in our webshop (www.teufelau-
dio.com) in the "Accessories" area.
USB soundcard with wireless transmission
The enclosed USB sound card g can be
used under Windows XP, Windows Vista
and Mac OS X without having to install
any drivers. The range of the wireless
transmission amounts to approximately 20 meters; walls
and furnishings may reduce the range.
To use the soundcard, screw the antenna f onto the
jack 5 "ANTENNA".
After connecting to a USB port on a computer, the
soundcard is available in the sound output control as a
"Wireless Player".
Inserting batteries
The wireless remote control
e is powered by 3 type
Micro/AAA batteries. They
are part of the product
contents.
In order to insert and/or
change the batteries, push
down the clip on the battery
compartment on the back of
the remote control, open the
compartment and remove
the cover. If necessary, take out the empty batteries
(please observe the notes on page 11).
Insert the batteries in the battery compartment as shown
in the figure.
Put the cover back on the compartment and push it
closed.
5
f
• Concept C 300
9
Advertisement
Table of Contents
