Connecting To A Power Supply; Basic Functions; Activating And Deactivating; Selecting A Source - Teufel concept c 300 black edition Technical Description And Operating Instructions

Connecting to a power supply

• Ensure that the mains switch 7 "Power" has been
turned off ("0 OFF" setting).
• Connect the mains connector jack 8 with a power sup-
ply socket via the mains cord d.

Basic functions

Activating and deactivating

• Using the mains switch 7, you can activate or deacti-
vate your Concept C 300. After activation, your device
is in standby mode and LED 1 "Standby" is red.
• With the button 1 "Standby" or 12
your Concept C 300 to operating and/or standby mode
(Standby). In the operating mode, the LED 1 "Standby"
is blue.

Selecting a source

After activation, the USB sound card is activated as a
source.
• Using the button 14 "Input", you can switch the source
between the USB sound card and RCA jacks.
When you switch, the LED 1 "Standby" is purple
briefly.

Adjusting the volume

• Increase the volume: Press the button 15 +.
• Decrease the volume: Press the button 15 –.

Adjusting the bass level

You can adjust the volume of the subwoofer separately.
1. Press the button 13 "Bass".
The LED 1 "Standby" is purple.
2. Adjust the base level as you like using the buttons 15
+ / – .
3. Press the button 13 "Bass".
The LED 1 "Standby" is again blue. If no button is
pressed for six seconds, the device will also switch to
normal operation.

Automatic standby

If there is no input signal for 20 minutes the subwoofer
will automatically switch to standby. To switch it back on
again, press the "Standby" button 1 or 12
10
• Concept C 300
, you can switch
.
8 7
1
12
13
14
15
d