Set Up - Health O Meter 2842KL User Instructions

SET UP

1. Place batteries in the battery holder (see "Replacing Batteries" below).
2. Plug the scale's AC adapter into the display assembly and into the power source.
3. Press the ON/OFF button to turn the scale on. The display will show "start" and
then "0.0".
4. When the self-test function is complete, the digital display should read "0.0".
5. Place a weight [not to exceed 600 lb (270 kg)] on the scale. The digital display will
blink " until the weight calculation is complete.
"
------
6. Press the LBS/KG button to select the weight mode, either in kilograms or pounds.
7. Press the REWEIGH button; the digital display should again read the weight of
the item on the scale.
8. Remove the weight from the scale. The digital display should continue to read the
weight of the item that was on the scale.
9. Press the ZERO button; the digital display should return to zero.
10. Disconnect the power source from the scale, then turn the scale on using
ON/OFF button. The scale should automatically switch to battery power.
NOTE: If the set up procedure failed, contact Health o meter Professional Scales Customer
Service at 1-800-815-6615.
Replacing Batteries
Figure 1. Replacing the Batteries
1. Disconnect the scale from the AC power source.
2. Unscrew two plastic screws and carefully remove the battery holder from the display
assembly.
3. Take the batteries from the battery holder, replace the batteries with new ones.
4. Position the battery holder into the display assembly and reinstall two plastic screws.
9