Health O Meter 2842KL User Instructions page 8

ASSEMBLY INSTRUCTIONS (CONT.)
5. Plug the display cable
connector into the base cable
connector.
6. Place the rubber mat in the
center area of the base
assembly platform.
7. Place the display assembly on
a table or mount it to a wall.
See the next section for
mounting instructions.
Display Assembly Wall Mounting Instructions
Caution: When wall mounting the display assembly, ensure that the mounting
location is free of electrical lines, gas pipes, and other safety hazards. Ensure that
wall is of construction that can support the display assembly.
Note: Display assembly can be mounted to a wall up to 6 feet (1.83 m) from the base.
1. If display head is already attached to the display assembly bracket, remove the
display assembly screws at the side of the display head and set them aside.
2. Position the display assembly bracket on the wall at the desired location and mark the
mounting bracket hole locations.
3. Use suitable plastic or metal anchors for the type of wall construction and carefully
drill the appropriate sized holes.
4. Insert the anchors into the wall, and screw the two mounting screws into the anchors.
Adjust the screw head depth such that the screw heads protrude 1/8" (3.2 mm) from
the wall.
5. Position the display assembly mounting holes onto the mounting screws and pull
down on the display assembly to secure the bracket over the screws.
6. Re-attach the display head to the display assembly bracket using the two display
assembly screws.
Required Parts Not Included With This Scale
(2) # 10-12 x 1 in. Screws
(2) Mounting anchors, compatible with wall construction
8