Table of Contents
Advertisement
WARNING
Allow heating element to cool
before cleaning the interior.
Failure to do so can result in
burns.
Outside
—Occasionally wash with a mild nonabrasive
detergent and water. Rinse and dry.
Inside
—
The inside of the dishwasher is self-cleaning
with normal use.
To clean stainless steel wipe with the grains.
Use a Dishwasher Safe Detergent to help with the stains or
discolorations.
NEVER
use products that contain Chlorine Bleach or
Citric Acid.
NOTE
Hard water may cause lime deposit buildup on the interior
of the dishwasher.
Winterizing
A dishwasher left in an unheated place should be protected
from freezing. Have a qualified person do the following:
To Disconnect Service:
1. Turn off electrical power to the dishwasher at the supply
source by removing fuses or tripping circuit breaker.
2. Shut off water supply.
3. Place a pan under the inlet valve. Disconnect water line
from inlet valve and drain into pan.
4. Disconnect drain line from pump and drain water into
pan.
5. Reconnect the water inlet pipe to the water valve.
6. Remove the filter at the bottom of the tub and use a
sponge to soak up water in the sump.
To Restore Service:
1. Reconnect the water, drain, and electrical power supply.
2. Turn on water and electrical power supply.
3. Fill detergent dispenser and run dishwasher through a
NORMAL WASH Cycle.
4. Check connections to make sure they do not leak.
Cleaning the Filter
For optimum performance, your dishwasher is equipped
with a filter assembly featuring a main, coarse and
fine filter as shown in the drawing above. All food
fragments are removed from the dishwasher as water
passes through the filter assembly.
CARE AND CLEANING
Burn Hazard
Each part of the assembly should be cleaned often to
ensure that all food fragments are removed from the
dishes. To remove food fragments from the filter
assembly, the filters must be removed from the
dishwasher. To remove the filters, pull up on the edge
of the main filter. Next, rinse the main filter and fine
filter under running water. Cleaning with a brush may
also be necessary to remove any fragments trapped in
the filters. Once cleaning has been completed, simply
reassemble the filter as shown in the drawing below. To
ensure that the filter is fully seated, please press down
on the top of the main filter. Using the dishwasher
without a properly installed filter is not
recommended as it will reduce the cleaning
efficiency and may damage dishware.
Cleaning the Spray Arm
-The spray arm may need to be cleaned to insure that
there are no clogs to the spray arm jets and bearings
due to hard water chemicals.
-To remove the upper spray arm, hold the nut and
rotate the spray arm clockwise to remove it.
-To remove the lower spray arm, pull up on the
spray arm.
-To clean the spray arm use warm soapy water using a
soft brush to clean the jets and bearings.
-To replace the spray arm simply set the spray arm on
the shaft, take the retaining nut and turn it counter
clockwise until it has locked into place.
Cleaning the Door
To clean the edge around the door: Use a warm, damp
and soft cloth. To avoid penetration of water into the door
lock and electrical components, do not use a spray cleaner
of any kind.
WARNING
Abrasive agents and rough paper towels/cloths
should not used, as it may scratch or leave spots
on the stainless steel surface.
Coarse
Filter
Main
Filter
Fine
Filter
10
Advertisement
Table of Contents
