Installation Instructions - Electrolux DFB09JFCWD Use And Care Manual

Freestanding dishwasher
Table of Contents

Advertisement

Positioning the Dishwasher
The back of the dishwasher should be positioned against
a wall and the sides of the dishwasher between two walls
or cabinets. Make sure your location has the correct drain,
water and electrical outlets to attach the connections.
Leveling the Dishwasher
The height of the dishwasher may be adjusted by
turning the leveling legs. Do not incline the
dishwasher more than 2 inches (5.08cm).
Electric Shock Hazard
Grounding Instructions:
The dishwasher must be connected to a grounded metal,
permanent wiring system or an equipment-grounding
conductor must be run with the circuit conductors and
connected to the appliance's equipment grounding terminal
or lead. It is the consumer's responsibility to contact a
qualified installer to make sure the electrical installation
conforms with the National Electrical Code and local codes
and ordinances.
Do not connect the dishwasher to the power supply until the
appliance is permanently grounded.
Do not use an extension cord. Such use can result in fire,
electrical shock, or other personal injury.
Failure to follow these instructions could result in death or
serious injury.
11

INSTALLATION INSTRUCTIONS

WARNING
Water Line Connection
Cold Water Line Connection
Connect the cold water supply hose to a threaded
3/4 inch connector and ensure that it is fastened
tightly in place.
Flush water line before connecting it to the water
inlet valve to prevent early clogging of filter screen.
Drain Hose Connection
Insert the drain hose into a drain pipe with a
mininum diameter of 40mm or let it run into the
sink, ensuring it is not bent or crimped.
Front
NOTE
The top of the hose
must be less than
1000mm.
Drain pipe
Draining Excess Water from Hoses
If the distance between the sink and floor is over
1,000mm, the excess water in the hose cannot be
drained directly into the sink. The excess water
will have to be drained from the hose into a separate
bowl or container that is lower than the sink.
Water Outlet
Connect the water drain hose. The drain hose must
be correctly fitted to avoid water leaks. Ensure that
the water drain hose is not kinked or squashed.
Extension Hose
If a drain hose extension is required, use a similar
drain hose that is no longer than 4 meters. Otherwise,
the cleaning performance may be reduced.
Air Gap
If you connect to a sink trap, local codes may require
you to install and air gap kit (not included). The drain
hose will be routed from the dishwasher to the air
gap inlet. An air gap kit is available from a plumbing
supply store. ( If the drain hose is installed through
the floor, an air gap is necessary.)
Counter
A
B
φ 40mm

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dfb09jfcsd

Table of Contents