Motorola NTN9176 ASTRO XTS User Manual page 9

Tri-chemistry vehicular charger
Table of Contents

Advertisement

6.
Rotate the unit to the preplanned mounting angle and tighten the two threaded knobs
holding the charger to the bracket.
Charger
Threaded
Knob (2)
Screw (4)
Washer (4)
.
7.
Referring to Table 1 and Figure 5, connect the red (A+) wire (with the inline fuse) of the
supplied cable to either an unswitched terminal on the vehicle's fuse box or directly to the
positive (+) terminal of the vehicle's battery.
8.
Connect the yellow (ignition sense) wire (with the inline fuse) to a switched terminal on
the vehicle's fuse box.
9.
Connect the black (Gnd) wire to any convenient vehicle ground.
10. The white wire is for vehicular repeater operation only. Please refer to installation
instructions for the vehicular repeater for instructions on the connection of this wire.
11. Carefully insert the connector on the end of the cable into the mating connector on the
back of the charger.
12. Recheck all wiring connections, cable routing, and all physical aspects of the installation
before turning on the ignition switch and testing operation.
Mounting
Surface
Figure 4 Installing the Vehicular Charger
Trunnion
Bracket
Lock
Washer (4)
Nut (4)
9

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents