Sony HCD-HDX285 Service Manual page 8

HCD-HDX285/HDX287WC/HDX585/HDX587WC/HDX589W/HDX685/HDX686W
HARNESS SETTING
lead pin
Note 2: Check not touch the heatsink.
PRECAUTION WHEN REMOVE GOOD OPTICAL PICK-UP BLOCK
CAUTION
Be sure to bridge here, and then disconnect the
wire (flat type) (24 core).
(optical pick-up block will be destroyed without bridging)
On the contrary at the installation, connect the
wire (flat type) (24 core) first, and then remove the bridge.
Note: For a soldering iron, use the one with a ground wire.
(Refer to DISASSEMBLY 3-12. OPTICAL PICK-UP BLOCK (KHM-310CAB or KHM-313CAB))
optical pick-up block
8
lead pin
lead wires
lead pin
wires (flat type)
Note 1: Check not touch the heatsink.
CN901
power cord
lead wire
wire (flat type) (24 core)
lead pin
Note 3: Insert fully until
CN3001
click the power cord.