Toyota 2003 Avalon Service Manual page 198

CALIBRATING THE COMPASS (circling
calibration)
Sometimes the direction display on the
compass may not change after a turn. To
rectify this, stop the vehicle and push the
"MODE" button several times
"COMPASS" appears and blinks on the
display. Then push the "RESET/ADJ" but-
ton. "CALIBRATE" appears and blinks to-
gether with the compass display.
194
'03 AVALON U (L/O 0206)
Drive the vehicle in a circle until the blink-
ing stops. If there is not enough space to
drive in a circle, drive around the block
until the blinking stops.
When the compass and the calendar dis-
until play return to normal mode, calibration is
complete.
If you want to cancel the calibration be-
fore it is complete, push the "MODE" but-
ton again.
2003 AVALON (OM41401U)
I n f o r ma t i o n P r o v i d e d b y :
Perform circling calibration just after
you have purchased your Toyota. And
then always perform circling calibration
after the battery has been removed, re-
placed or disconnected.
D
Do not perform circling calibration of
the compass in a place where the
earth's magnetic field is subject to in-
terference by artificial magnetic fields
(underground parking, under a steel
tower, between buildings, roof parking,
near a crossing, near a large vehicle,
etc.).
D
During calibration, do not operate elec-
tric systems (moon roof, power win-
dows, etc.) as they may interfere with
the calibration.
CAUTION
D
When doing the circling calibration,
be sure to secure a wide space,
and watch out for people and ve-
hicles in the neighborhood. Do not
violate any local traffic rules while
performing circling calibration.
D
Do not adjust the display while the
vehicle is moving. Be sure to adjust
the display only when the vehicle is
stopped.