Magnifying And Searching For Details; Selecting The Aspect Ratio - BenQ MX813ST User Manual

Magnifying and searching for details

If you need to find the details on the projected picture, magnify the picture. Use the
direction arrow keys for navigating the picture.
• Using the remote control
1. Press Digital Zoom+/Digital Zoom- to
display the Zoom bar.
2. Press Digital Zoom + to magnify the center
of the picture. Press the key repeatedly until
the picture size is suitable for your need.
3. Use the directional arrows ( ,
on the projector or remote control to
navigate the picture.
4. To restore the picture to its original size,
press AUTO. You can also press Digital Zoom -. When the key is pressed again,
the picture is further reduced until it is restored to the original size.
• Using the OSD menu
1. Press MENU/EXIT and then press
2. Press to highlight Digital Zoom and press MODE/ENTER. The Zoom bar
displays.
3. Repeat steps 2-4 in the section of
using the projector control panel, continue to the following steps.
4. Press on the projector repeatedly to magnify the picture to a desired size.
5. To navigate the picture, press MODE/ENTER to switch to the paning mode and
press the directional arrows ( ,
6. Use the directional arrows ( ,
navigate the picture.
7. To reduce size of the picture, press MODE/ENTER to switch back to the zoom in/
out functionality, and press AUTO to restore the picture to its original size. You can
also press
The picture can only be navigated after the picture is magnified. You can further magnify the
picture while searching for details.

Selecting the aspect ratio

The 'aspect ratio' is the ratio of the image width to the image height. Most analog TV and
computers are in 4:3 ratio,
are usually in 16:9 or 16:10 ratio.
With the advent of digital signal processing, digital display devices like this projector can
dynamically stretch and scale the image output to a different aspect than that of the image
input signal.
To change the projected image ratio (no matter what aspect the source is):
1. Press Menu/Exit and then press
2. Press to highlight Aspect Ratio.
3. Press / to select an aspect ratio to suit the format of the video signal and your
display requirements.
32
Operation
, ,
/
"Using the remote control"
, ,
, ,
repeatedly until it is restored to the original size.
which is the default for this projector, and digital TV and DVDs
/
)
until the DISPLAY menu is highlighted.
above. Or if you are
) to navigate the picture.
) on the projector or remote control to
until the DISPLAY menu is highlighted.