Lid Assembly Removal; Disk Base Assembly Removal; Base Unit Removal; Bu Holder Removal - Sony DVP-PQ2 Service Manual

Note: Follow the disassembly procedure in the numerical order given.

2-1. LID ASSEMBLY REMOVAL

2-2. DISK BASE ASSEMBLY REMOVAL

1 Four ornamental sheets (screw)
2 Four ornamental
screws (M3 x 12)
Note: When you tighten four screws, in order not to make a crevice
between a disk base and a lower case, please hold from both
sides.
SECTION 2
DISASSEMBLY

2-3. BASE UNIT REMOVAL

3 Disk base assembly

2-4. BU HOLDER REMOVAL

3Two screws
(+BV3 x 10)
6 Three screws
(M2 x 8)
7 Four screws
(+BV3 x 10)
7 Two screws
2-1
1 Three INS screws
2 Base unit
3 Two flexible flat cables
(FMP-006, 005)
4 SW panel assembly
0 SW 406 board
5 Two screws
(+BV3 x 10)
8 BU holder
(+BV3 x 10)
2 Connector
(CN950)
DVP-PQ2
1 Flexible flat cable
Harness
(IS-059)
(CN811)
9 Flexible flat cable
(CN203)(CN204)