Section 10: Start Up Sequence - Montigo L42DF ST Installation & Maintenance Manual

Section 10: Start up Sequence

For Your Safety - READ BEFORE LIGHTING:
A. This appliance is equipped with an ignition system that lights
the pilot burner automatically. Do not attempt to light the pilot
by hand.
B. BEFORE LIGHTING smell all around the appliance area for
gas. Be sure to smell next to the floor because some gas is
heavier than air and will settle on the floor.
What To Do If You Smell Gas:
Do not try to light any appliance.
„
Do not touch any electrical switch; do not use any phone
„
in your building.
Immediately call your gas supplier from a neighbour's
„
1. STOP! Read the safety information above on this label.
2. Lift out the lower Horizontal access panel.
3. Push in gas control knob and turn clockwise
"OFF."
4. Wait five (5) minutes to clear out any gas. Smell for gas,
including near the floor. If you then smell gas, STOP!
Follow "B" in the safety information above on this label.
If you don't smell gas, go to the next step.
5. Locate pilot burner (See illustration at right.) and follow
steps below.
6. Turn knob on gas control counter clockwise
NOTE: Gas control knob cannot be turned from "PILOT" to
"OFF" unless knob is pushed in slightly. Do not force.
1. Turn off remote switch.
2. Lift out the lower Horizontal access panel.
XG0182 - 151126
Operation
with American Flame Electronic Ignition
Standing (Continuous) Pilot Ignition
Lighting Instructions:
to
to
To Turn Off Gas To Appliance:
WARNING
If the information in these instructions is not followed exactly, a fire or explosion may
result causing property damage, personal injury or death.
WARNING/ CAUTION: Hot while in operation. Do not touch.
Severe burns may result. Keep children, clothing, furniture,
gasoline and other liquids having flammable vapours away.
See installation and operating instructions accompanying this
appliance.
phone. Follow the gas supplier's instructions.
If you cannot reach your gas supplier, call the Fire De-
„
partment.
C. Use only your hand to push in or turn the gas control knob.
Never use tools. If the knob will not push in or turn by hand,
don't try to repair it, call a qualified service technician. Force
or attempt to repair may result in a fire or explosion.
D. Do not use this appliance if any part has been under water.
Immediately call a qualified service technician to inspect the
appliance and to replace any part of the control system, and
any gas control which has been under water.
(SIT NOVA 820)
"PILOT."
7. Push in gas control knob completely and hold. Light with
Piezo Igniter button. Continue to hold the control knob in
for about (1) minute after the pilot is lit. Release the knob
and it will pop back up. Pilot should remain lit. If it goes
out repeat steps 3 through 8.
If knob does not pop up when released. Stop and immediately
„
call your service technician or gas supplier.
If the pilot will not stay lit after several tries, turn the gas
„
control knob to "OFF" and call your service technician or
gas supplier.
8. Push in gas control knob and turn counter-clockwise
to "ON."
9. Replace the lower Horizontal access
panel.
10. Turn on remote switch to ignite fire.
3. Push in gas control knob slightly and turn
to "Off". Do not force.
4. Replace the lower Horizontal access panel.
L42DF-ST* Indoor Gas Fireplace
clockwise
Page 27