Section 7: Screen Installation And Removal - Montigo L42DF ST Installation & Maintenance Manual

L42DF-ST* Indoor Gas Fireplace

Section 7: Screen Installation and Removal

Removing / Attaching Screens:
To Remove Screens:
Grasp each top outer corner of the screen with your thumb
and finger and pull towards yourself. When the upper Screen
Studs are free, lift the screen at an angle from the lower
slots from which the Screen Bottom Tabs are held. Place
the screen in a safe place.
To Install Screens:
Hold the screens at an angle away from the fireplace, and
locate the Screen Bottom Tabs at the lower corners of the
screen. Place the screen into the Screen Tab Receptacles
in the lower section of the fireplace.
Make sure the tabs and screens are lowered all the way down
into the Screen Tab Receptacles on the fireplace. Then, push
each Upper Screen Stud on the top corners of the screen
into the Upper Screen Stud Receptacles in the fireplace.
Figure 22a. Screen Door Numbers (Replacement Parts)
Page 24
Installation
Upper Screen
Stud Catch
Screen Tab
Receptacles
Figure 22b. Screen Installation and Removal
Replacement Screens:
For replacement part order numbers, please refer to section
"Replacement Parts:" on page 36.
Note: Do not operate fireplace without all screens in place.
Left Side Detail
Left Side Detail
Upper Screen
Removing /
Studs
The Safety S
To Remove the sc
Simply grasp e
outer corner of
with your thum
finger and pull
you. Once the
Screen Studs a
an angle, lift th
from the lower
which the Scre
Tabs are held.
screen in a saf
To Install the Scre
Holding the sc
angle away fro
fireplace, locat
Screen Bottom
lower corners o
screen into the
Tab Recepticle
lower section o
fireplace. Make
tabs and scree
lowered all the
into the Screen
Recepticles on
fireplace. Then
Upper Screen
top corners of
into the Upper
Stud Catchs in
fireplace.
Screen Bottom
Tabs
XG0182 - 151126