Table of Contents
Advertisement
LA-140 – Mounting your Radiator
4
Pull CAT-5 and Coaxial cables through (if necessary)
Pull CAT-5 and Coaxial cables through hole in Wall Box Plate
5
Determine correct angle
Determine correct angle setting to use for the radiator, see page 11 of designing a system.
6
Attach Radiator to Wall Box Plate
Attach Radiator to Wall Box Plate using Tilt Arm "A" and Tilt Arm "B". Use the Tilt Bolt to fasten the tilt arms together.
ATTENTION: Note the angle measurements on Tilt Arm "B" and verify that the correct angle is selected
7
Attach Safety Mounting Cable
The radiator has a safety cable attached to the top of the swing arm. This cable must be attached to a secure base to
prevent the radiator from falling in the event of a mounting hardware component failing. Possible injury to persons and
damage to the radiator is prevented by securely attaching this cable to a base.
8
Connect CAT-5 and Coaxial cables
Connect CAT-5 and Coaxial cables to appropriate locations on radiator.
l
40
before fully tightening Tilt Bolt.
attach to a secure base
Hide quick links:
Advertisement
Table of Contents
